Floor Mixer

Ultra smooth floors (glass-smooth) are often a "necessary" look to demonstrate the quality of operations and merchandise. As is often the case for an outcome upscale, smooth glass floors are achievable but at a cost of materials and effort. Of course, it helps to start with a smooth floor but even highly damaged floors can be reduced to a smooth glass with hard work and ... epoxy.

If you are going to invest to achieve a quality smooth showroom floor, you first want to assure you that your efforts are not spoiled by lifting or peeling. This means that care must be taken to a work of preparation that ensures a good grip on the concrete base. A good way to get professional preparation is to use kits Durall Industrial Flooring materials that are adapted to the specifications of the owner and delivered directly on the site. These kits include complete instructions and Help 24 / 7 lines composed of seasoned experts floor, so professionals and amateurs can successfully install a quality floor. See www.concrete floor-coatings.com for more details.

After the preparation work is completed, all the weak points of your floor should be completed. Joints and cracks in concrete subsidence can be filled with grout provided in the kit Durall. Mix the grout to the consistency of peanut butter and work in the cracks of a gloved hand or putty knife is the first step. Try not to smear too much on the surface and the strike cracks rinse before hardening.

Then there are holes from the tack strips feared or walls that have been withdrawn, or stones showing through water erosion. These must all be filled with epoxy to 100% for maximum grip. Make sure all holes are dry and the dirt has been sucked out of them during the preparation process. Mix up the epoxy and pour a small amount in each crater and the hole. Note that the surface tension of the epoxy resin to create a small advantage in each heat, like honey poured on a counter. Once the epoxy has set up (12-15 hours) using a grinder with a masonry wheel to bring the sides level with the surrounding concrete. Then use a vacuum cleaner to remove all the soil out of powder and slurry furniture that can be on the floor.

Then your 100% solids Dura Poxy coating. For a smooth glass that you need to plan on three layers. The first layer is brushed and rolled approximately 125-150 square feet per gallon. When mixing, be sure to make at least 200 strokes or 2 minutes with a mixer drill. Then transfer the mixing container into another container before application to ensure that no material remains unmixed. Use a 9-in. 3 / 8 nap roller "and a 4-in. China brush broom handles to apply. Mix the epoxy as you're going to make sure it remains fluid and seamless as possible. Mixing and application of the resin epoxide in 30 minutes that will flow well. After 15 hours, you screen the entire floor of a 60-screen grain on a rotary scrubber. Next, check all areas patched. If holes or cracks filled show imperfections, applying additional epoxy low points, allowing them to Harden, and grinding may be necessary to finish this glass smooth.

For the second layer, the plane about 90 square feet per gallon. Be sure to vacuum thoroughly before proceeding with an additional layer. Again, mix the epoxy that you need and add it to the end of the floor, then use a 16-in. notched squeegee to remove the material on the surface. The serrated blade allows additional equipment to flow into all the spots with low to make them. Pull about 6 feet and then use 3 / 16 nap roller "and shoot dry areas to remove the brands rack or pools that may appear. Fifteen (15) hours later, the screen again, draining well and repeat the process to arrive at your final stage.

Customers can obt.